0

Hi,

I’m currently trying to enter debug mode using the GCC for Renesas RL78 4.9.2.201803-GNURL78-ELF toolchain but the program has stalled at the “Configuring GDB” dialog (Extracting RL78 Debug).

The debugger works however if the KPIT GNURL78v15.02-ELF Toolchain is selected.

I select the GCC toolchain from the Toolchain tab of the Project->Properties->C/C++ Build window and then click “Apply and Close”… When I rebuild the project and try to debug, the dialog progresses close to the end and then stalls (image attached).

When I perform the same sequence with the KPIT toolchain, everything is fine…

I am developing for an RL78 device (R5F104PJ) using e2studio 7.2.0. My debugger is an E1.

Any ideas?

Thanks for your help,

Steve

Attila Banyai 回答済